3/64 CARBIDE SPADE DRILL BIT for Spring Eyelet in Blade
92.90%, 135 sales
Ask seller a question
Money Order, Cashier's Check, Personal Check,
These 3/64 solid carbide spade drills are made in the U.S.A. and are used for drilling spring holes in pre-hardened blades.
If you’re converting a knife, these are what you need to make the acceptor hole needed for the coil spring tip. Very high quality!
Size (Inch): 3/64
Size (Decimal Inch): .0469"
Flute Length (Inch): 7/32
Overall Length (Inch): 1-1/2
Drill Point: 118
Material: Solid Carbide
Web Thickness (Decimal Inch): .012
Carbide is very brittle any side to side motion will snap the bit, do not use a hand held drill for this.
Use only in a drill press otherwise you will snap the bit.
Other Products from exiled:
View all products
Exiled Cutlery CYCLONE 5 Hole Red Aluminum Handles
Microtech UTX-85 Black Oxide Tactical Glass Breaker Skull Splitter
Microtech Combat Troodon OTF Replacement Tanto Partially Serrated Blade
Exiled Cutlery Trainer Bushing Hair Comb Blade Double Tang Pin
Push Button w/ Actuator Spring Replacement for Smith & Wesson Extreme Ops
1/8 Brass Washer Set of 4
25/64 ASIAN Right Hand Wound Coil Spring for Asian Made Knives
2.5mm Black Handle Hardware Screw Replacements for Smith & Wesson ExtremeOPS, HRT & Schrade Extreme
Microtech Xtra-Large Tri-Bit Screwdriver Bit - Fits LUDT Models
Exiled Cutlery CYCLONE 5 Hole Blue Aluminum Handles
Last Updated: 24 Mar 2017 16:49:55 PDT
Powered by eCRATER - a
free online store builder