#59 (.041") CARBIDE DRILL BIT for Spring Eyelet in Blade
92.90%, 135 sales
Ask seller a question
Money Order, Cashier's Check, Personal Check,
#59 (.041") Tungsten Carbide drill bits are used for drilling spring holes in pre-hardened blades.
These have a standard 1/8" shaft and a needle sharp drill point.
If you’re converting a knife, these are what you need to make the acceptor hole needed for the coil spring tip.
Very high quality!
Size (Inch): #59
Size (Decimal Inch): .041"
Material: Solid Carbide
THESE ARE AWESOME
These should be used in a drill press or CNC drilling machine as the end will break if used in any hand held drill because Carbide does break with side to side motion.
They work just fine in a hand held drill but that is a risk you will have to take if you are nutty enough to try it but they work best in a drill press so if you got one I suggest you use it.
Other Products from exiled:
View all products
1/8 Brass Washer Set of 4
Microtech Triangle Screwdriver Bit - Fits Pivot Screws on Whaleshark Model
Microtech Troodon Black Oxide Tactical Glass Breaker Skull Splitter
1/2 MEGA Torque Coil Spring Boker & Smith & Wesson LARGE Models
Microtech Scarab OTF Black Tactical HEX Alan Head Screw (Set of 6)
Microtech EARLY Ultratech OTF Black Tactical HEX Alan Head Screw (Set of 6)
Exiled Cutlery FU42 Trainer Olive Drab Blade Replacement Single Tang Pin
3/8 Coil Spring Cutter Double Sided Bit .375
Exiled Cutlery TITANIUM 5.5" Long Solid Titanium Handles
Exiled Cutlery TWISTER 5 Hole Stainless Steel Handles
Last Updated: 24 Mar 2017 16:49:55 PDT
Powered by eCRATER - a
free online store builder